demixing是什么意思_demixing怎么读_demixing的用法_翻译_短语搭配_权威例句

同近义词

• n.分层

  delamination   /   separated layer

词组短语

1. self demixing 自分层

2. demixing area 混合物分层的区域

3. demixing effect 反混合效应 ; 分层效应

4. demixing point 分层点

5. Demixing fluid 分层液

6. demixing matrix 解混矩阵 ; 解混合矩阵

权威例句

1. This demixing effect leads to the difficulties in the control of alloy composition of coating and in the design of composition of alloy cathode target.

这种离析效应导致了合金涂层成分控制及合金靶材成分设计的困难。

2. In sensors noise model, PCA is introduced to the samples of observed mixtures, and then the obtained principal components are set as the input of demixing network. Simulations show that this approach can improves SNR of the output of demixing network. 3.

在有观测噪声混合模型中，本文通过先对观测得到的混合信号样本做主分量提取，再将其作为分离网络的输入，以此提高了分离网络输出信号的信噪比。

3. Studies of Demixing of Composite Target in Vacuum Arc Deposition for Multielement Films Growth

真空电弧沉积多元膜复合靶成分离析效应的研究

4. The separation behaviour was quantitatively evaluated by initial demixing time and subsidence ratio.

然后以初显分离时间和沉降率为量化指标，定量研究了低取代度阳离子淀粉的变性深度、混合比例及PVA分子结构对淀粉与PVA混合浆液的相分离行为的影响。

5. Special attention is paid to thermodynamics, phase transition ( like liquid-liquid demixing, crystallization, gelation and vitrification), membrane formation mechanism and membrane morphology.

对浸入沉淀相转化法制备聚合物分离膜的过程热力学、发生的各种相转变（液-液分相，聚合物的结晶、凝胶化和玻璃化转变等）、成膜机理和膜结构形态进行了分析。

6. The composition demixing phenomena of the coatings and composite target were analyzed.

在沉积过程中存在着多元合金涂层与复合靶的成分离析现象，这与靶材的结构有关。

7. The casting solution viscosity increases with the increase of TEP content in the mixed solvent, which results in a slower demixing rate during the precipitation process.

随着混合溶剂中TEP含量的增大，铸膜液的黏度增大，分相速率减慢；

8. DMAc solvent as a coagulation bath, resulting in concrete slowing, chemical potential of diffusion mass transfer between solvent and non-solvent changed, which induced delay demixing, membrane structure changed from finger-like structure to spongy structure.

以溶剂DMAc的水溶液作凝胶浴时，凝胶浴的凝固能力降低，降低了溶剂与非溶剂扩散传质的化学势变化，容易发生延迟相分离，断面结构从指状向海绵状转变。

9. Comparing the gelation time with delay time, it found that for both instantaneous and delay demixing systems gelation time was much longer than delay time.

与延迟分相时间的比较实验揭示了：无论对延迟分相体系或是对瞬间分相体系，成膜过程中的凝胶时间远大于延迟分相时间。

10. Based on an intensive analysis of spinodal demixing in this curing system, a physical model has been put forward, in which two processes have been abstracted to describe the reaction-induced phase separation.

在对旋节线相分离模式深入分析的基础上，提出了双函数模型来描述相分离过程。

11. Acquirement of High Purity Basal Cell with Application of Dispase II and Lymphocyte Demixing Fluid

应用DispaseⅡ与淋巴细胞分层液获取高纯度基底细胞

12. The smaller the slope of tieline, i. e. the less the nonsolvent in the polymer-lean phase while demixing happen, the shorter the gelating time.

联结线的斜率越小，即分相时聚合物稀相中非溶剂的量越少，凝胶时间越短。

13. Secondly, when water and IBA were chosen as coagulation solution, characteristic of phase separation ( instantaneous demixing and delayed demixing) of multicomponent PSF systems are determined by light transmission in the process of performance membrane.

其次，将PSF多元体系分别以水和醇类作凝固浴，利用成膜过程中透光率实验测得对应体系的相分离特性（瞬时分层或延时分层）。

14. The reasons for this phenomenon and the influence of the sulfide scale demixing on the sulfidation process of Fe-Cr alloys have been discussed.

文中讨论了这种现象的原因以及硫化层分层对铁铬合金硫化行为的影响。

15. The results showed that the working arc current and average current of arc spot of the mosaic cathode materials strongly affect composition demixing. Composite target of Ti/ Me has a balance point with no demixing.

结果表明，工作弧电流和阴极镶嵌体的弧斑平均电流对成分离析效应影响程度较大，Ti/Me复合靶存在一个无成分离析效应的平衡点。

16. Methods The defect area and position was located according to skull fault X-ray. The donor bone was made and demixing suture and pressed with gauze.

方法采用颅骨断层X光片了解颅厚度，依据缺损范围确定所取颅骨外板的面积与部位，制取供骨并做相应处理后分层缝合，加压包扎。

17. Analysis on Improvement of Demixing Combustion Technology and the Boiler's Performance

分层燃烧技术的改进和锅炉综合性能分析

18. A study on the physical mechanism of composition demixing effect in alloy coatings deposited by multi-arc ion plating

多弧离子镀合金涂层成分离析效应的物理机制研究

19. The phase separation rate during the membrane formation process was measured by the light transmission method. The liquid-liquid phase separation happens at about 1 minute after the gel demixing.

光透射曲线法测定了成膜时的相分离速度，结果表明成膜过程中，在凝胶分相后约1min出现了液液分相。

20. An analysis of the demixing matrix's dynamic changing in available blind source separation algorithms with an unknown number of sources is made and the conclusion that it is the redundant movement of demixing matrix in some equivalent class which cases the divergence is drawn.

分析了已有源信号数目未知的盲信号分离算法中分离矩阵的动态变化，找到了分离矩阵范数趋于无穷大而导致算法发散的原因：分离矩阵在某一等价类中的冗余移动。

21. The influences of starch viscosity upon the phase-separation behaviors of starch/ PVA blend pastes were evaluated in terms of initial demixing time, volume percentage of phase separation, and subsidence ratio. The variations in starch viscosity were achieved by adjusting the reaction time of starch acidation.

通过控制淀粉酸解时间以制取不同粘度的淀粉试样，并以混合浆液的初显分离时间、相分离百分率和沉降率为量化指标，研究了淀粉粘度对淀粉/PVA混合浆液相分离行为的影响。